Skip to main content

Internet Power Unit

Specifications

Dimensions:
220mmx190mmx80mm (H x W x D)
Features:
  • Cold Start 15A/115V AC, 30A/230V AC
  • Overload Protection 115% ‐ 135% of the rated power, pulsing hiccup shut down, auto recovery
  • Overvoltage protection
  • Short circuit protection, recovery
  • Low power consumption, high reliability
  • 100% full load burn‐in test
  • Audible tone for mains fail
  • Battery protection circuit built in
  • Battery charger is intelligent - switch mode charging processed by a PIC processor
Power Rating:
Output: 12V 3.5A
Battery:
12V 7AH Battery used as standard
Standard Cables:
The IPU comes standard with 2 x 1.5m cables with industry standard 2.1mm moulded plugs
Caution:
  • The unit will dissipate a small amount of heat so please ensure that the unit is installed in a place where there is sufficient ventilation
  • This unit must not be installed outside as it is not protected against water
  • Mounting, maintenance and repair must be carried out by a skilled and authorised person
Warranty:
This product carries a one year warranty and is subject to proper installation procedures and must be installed by a qualified person
Standards:
Complies with EN55022, EN61000‐3‐2, 3, EN55024, SANS IEC 60 950

https://www.linkedin.com/in/ronaldxbartels/
Labels:

Comments

Post a Comment

Popular posts from this blog

LDWin: Link Discovery for Windows

LDWin supports the following methods of link discovery: CDP - Cisco Discovery Protocol LLDP - Link Layer Discovery Protocol Download LDWin from here.
Post a Comment
Read more

Battery Room Explosion

A hydrogen explosion occurred in an Uninterruptible Power Source (UPS) battery room. The explosion blew a 400 ft2 hole in the roof, collapsed numerous walls and ceilings throughout the building, and significantly damaged a large portion of the 50,000 ft2 building. Fortunately, the computer/data center was vacant at the time and there were no injuries. Read more about the explosion over at hydrogen tools here .
Post a Comment
Read more

STG (SNMP Traffic Grapher)

This freeware utility allows monitoring of supporting SNMPv1 and SNMPv2c devices including Cisco. Intended as fast aid for network administrators who need prompt access to current information about state of network equipment. Access STG here (original site) or alternatively here .
Post a Comment
Read more